After setting the standard for K swaps in the 86 and Miata platforms, we’re now bringing the same innovation and simplicity to any chassis. Our Universal Electronics Package is built to simplify custom K swap builds by making wiring more intuitive and less time-consuming, regardless of the vehicle.
This complete solution includes everything you need, bundled for both savings and performance. At its core is the proven Haltech Elite 1500 ECU, paired with our Universal RWD Drive-By-Wire Engine Harness, our KPower Fuse Box, the Bosch dual oil temp and pressure sensor, and a Haltech Wideband O2 sensor kit.
You can also add a Haltech CAN Gauge, iC-7, or uC-10 digital dash and get an additional 8% off when you bundle!
For installation, attach the engine harness to your engine, mount the fuse box to the chassis, and connect the fuse box ring terminal to a 12V power source. Then, connect the C101 connectors from the engine and fuse box, and run new wires from the 2- and 3-pin connectors to your starter, fuel pump, and radiator fan. You'll need to manually wire in your vehicle speed sensor utilizing the included terminal pins. It’s that simple!
The wiring diagram and FREE Haltech basemap can be downloaded for his package on our Installation and Basemaps page.
Key features of converting to drive by wire:
- Razor sharp throttle response, just like drive by cable
- No lift shifting (flat shifting)
- Automatic throttle blipping into apex of corners
- Launch control
- Traction control
- Integrate fail safes into your tune such as lean AFR, low oil pressure, over-boosting, and etc.
Engine Wiring Harness Features:
-
100% plug and play, designed to connect directly to the Haltech Elite 1500 A and B ports
-
OEM C101 cabin harness connector with matching female side included
-
DTM 6-pin connector for easy integration with any DBW pedal
-
Bosch 74mm DBW throttle body connector
-
All-new OEM K-Series connectors
-
Modular fuel injector sub-harness for quick swaps
-
High-temp Teflon-coated wire
-
Raychem DR-25 heat shrink loom for durability and heat protection
-
Flex-fuel input pre-wired and ready for ethanol sensors
-
Pre-wired for Bosch oil pressure and temperature sensor
Notes:
- This harness is currently only available as-is. No modifications or cable throttle options are offered at this time.
- All products are designed for off-road motorsports use only. Users are responsible for complying with all local laws in their county, state, and country.
- Note that our engine wiring harness is designed for 2004-2008 K24A sensors, including the crank sensor, knock sensor, and injectors.
-
This harness does not integrate into any OE Manufacturer CAN BUS system.
KPower Recommended Supporting Products:
